11. Rotate the pulley two turns anti-clockwise.
12. Release the starter cord slowly.
13. Pull on the starting handle, check the function.
14. Pull out the starter cable, at the same time grip
the starter disc and check that if it can be
turned anticlockwise another half turn. If not,
the spring has been over-tightened and is
touching the bottom, the starter cable must
therefore be loosened a turn.
15. Fit the starting mechanism.
16. Check the function.
Troubleshooting
If the petrol breaker does not start, has low power
or runs unevenly, check the following points.
◆
Check that there is fuel in the tank.
◆
Check that the spark plug is undamaged and
that the electrode gap is 0.6–0.7 mm
(0.024-0.028 in.).
◆
Check that the air filter is clean and not
clogged.
◆
Check that the working tool in use has the
correct shank dimensions.
◆
Check that the cooling air inlet is not blocked or
covered.
If the machine still does not function satisfactorily
or if the LED service lamp is lit, contact an
authorised workshop.
Storage
◆
Empty the tank before storing the machine.
◆
Check that the machine is properly cleaned
before putting it away for storage.
◆
Store the machine in a dry place.
◆
We recommend to store the machine in a
standing position. If stored in a lying position,
the machine must be placed on the back cover.
◆
If the machine is stored on a stick and/or
storage rack the insert must not exceed more
than 155 mm (6.10 in.). If the maximum insert is
exceeded the machine can be destroyed.
◆
Keep the machine and tools in a safe place, out
of the reach of children and locked up.
Disposal
A used machine must be treated and deposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative
influence on the environment is kept as low as
possible, and in respect to local restrictions.
Before a petrol driven machine is deposited it must
be emptied and cleaned of all oil and petrol.
Remaining oil and petrol must be dealt with in a
way that does not affect the environment.
COBRA PROi Safety and operating instructions
© Construction Tools PC AB | 9800 1758 01 | 2017-01-10
Original instructions
19
To Next Page
Loading...
Need help?
General
