Need help?Do you have a question about the Atlas Copco FlexiROC T30 R and is the answer not in the manual?
General| Brand | Atlas Copco |
|---|---|
| Model | FlexiROC T30 R |
| Category | Construction Equipment |
| Language | English |
Always read safety information before operating or maintaining the machine.
Defines the product's intended applications and lists forbidden uses.
Introduces the remote control system, its components, and basic operation.
Critical safety warnings for using the remote control system safely.
Details the operation of the left-hand lever for positioning and rod handling.
Explains the functions of the right-hand lever for boom and drilling control.
Describes proportional functions for rotation and feed using the right-hand lever.
Explains common error messages and indications on the startup screen.
Covers turning battery power ON/OFF and activating the remote control.
Steps for starting the diesel engine, cold starting, warming up, and regeneration.
Procedure for safely shutting down the diesel engine, considering warm-up.
Critical safety warnings regarding tipping risk and accidental operation during tramming.
Critical safety warnings for using the winch, covering moving parts, cable failure, and accidental operation.
Explains the use of the winch for extra thrust or as a brake during tramming.
Detailed procedure for tramming uphill using the winch.
Detailed procedure for tramming downhill using the winch.
Step-by-step guide to positioning the machine horizontally and securing it.
Crucial safety warnings about moving parts and accidental operation during drilling.
Procedure for loading drill rods using the RAS system.
Steps to prepare the drill rods and machine for the drilling process.
Steps for setting up the machine for drilling, including safety precautions for tipping and overloading.
Steps to prepare the drill rods and machine for the drilling process.
Step-by-step guide for drilling a hole, including starting rotation, flushing, and feed.
Procedures for stopping the drilling operation, including switching percussion modes.
Procedure for automatic drilling, including compressor loading and starting rotation.
Step-by-step procedure for adding extension rods to the drill string.
Specific steps for adding extension rods using the RHS system.
Specific steps for adding extension rods using the RAS system.
Procedure for unthreading and extracting drill rods.
Specific steps for unthreading and extracting drill rods using the RAS system.
Procedure for replacing the drill bit, with safety warnings.
Detailed steps and safety notes for hoisting the drill rig.
Checks for emergency stops, work lights, and coolant level.
To Next Page
