EasyManua.ls Logo

Atlas Copco FlexiROC T30 R - Wash Machine Externally; Check Condition of Signs

Atlas Copco FlexiROC T30 R
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FlexiROC T30 R 6 Daily Maintenance
108 No: 2969809547.1.2969824267 en-US
M Jack
- All emergency stops
Checkpoints Remote Control
A Rubber bellows on levers and switches
B Seals on switches and knobs
C The joint between the upper and lower halves of the remote control must be tightened.
D The remote control must not be cracked
6.4 Wash Machine Externally
Disconnect fire-fighting equipment if steam washing or high-pressure washing.
n
Rinse the machine with water at least once a day to remove drill cuttings, mud, and
dirt.
The feed, front part of the boom, and track frames are particularly important to keep clean.
6.5 Check Condition of Signs
n Make sure all signs are intact, clean and fully readable.
n Make sure all signs are in place. Compare with the drawing.
n Always replace defect or missing signs.

Table of Contents

Other manuals for Atlas Copco FlexiROC T30 R

Related product manuals