Atlas Copco FlexiROC T30 R

FlexiROC T30 R 4 Operation
89 No: 2969809547.1.2969824267 en-US
10.
Open the drill rod supports with circuit breakers (M) and (N).
4.4.13 Adding Extension Rods with RHS
Precondition
1.
Make sure that the upper drill rod support (for locking the sleeve) is closed. (See sec-
tion on controls, upper drill rod support switch.)
2.
Fully unthread the shank adapter from the drill sleeve. Right multi-function lever (E)
position (H).
3.
Move right multi-function lever to sector (C) to rapid-feed backwards until the rock drill
stops in its top position above the rod carousel.
4.
Move left multi-function lever (A) to sector (B) to move a new drill rod into the rod han-
dling arms.