Atlas Copco FlexiROC T30 R - Checking before Using the Winch

FlexiROC T30 R 4 Operation
70 No: 2969809547.1.2969824267 en-US
n The machine must be switched off during anchoring or adjustment of the cable.
n A damaged cable must always be replaced.
It is of the utmost importance that the cable is correctly fitted in the winch eye. It must be
checked:
n Before each use
n When replacing the cable
n When first attaching the cable after shortening
4.2.10 Checking before Using the Winch
The following must be checked before each use of the winch.
n
Check that the cable (A) is attached correctly in the connector sleeve and eye. The
cable must run in line with the eye on the connector sleeve.
n
Check that the cable has not sustained any damage.
n
Check that there are at least 4 turns remaining on the drum. The winch must never be
used with fewer than 4 turns remaining on the drum.
4.2.11 Preparing for Tramming with Winch
WARNING
Tipping Risk
The tipping over of a machine can cause serious injury or death.
u Never exceed the maximum allowed inclination angles for the machine.
u Never combine inclination angles for downward/upward/lateral tramming.
u Never operate the drill rig from the down side.
u Keep the winch cable continuously taut.