FlexiROC T30 R 4 Operation
78 No: 2969809547.1.2969824267 en-US
4.
Position the feed beam to horizontal position.
5.
Open the drill rod support (switch M and N).
6.
Move the drill rod in through the drill rod support and then close (switch 12 and 13)
the drill rod support.
7.
Screw the shank adapter fully into the sleeve of the drill rod. Right-hand multi-function
lever sector (G).
8.
Open the drill rod support and rapid feed backwards right-hand multi-function lever in
sector (C) until the rod is almost out of the drill rod support.
9.
Open the claws by turning the left-hand multi-function lever to sector (E). Move the
rod handling arms to drill center by moving the left-hand multi-function lever to sector
(C).
10.
Grip the drill rods with the claws by moving the left-hand multi-function lever to neutral
position.
11.
Rapid feed backwards right-hand multi-function lever sector (C). Continue until the
rock drill has stopped at the correct height for the drill rods to be moved into the
carousel. The claws automatically adopt loose grip for rapid feed.
To Next Page
Loading...
Need help?
General
