Safety and operating instructions
© 2010 Atlas Copco Craelius AB | 2010-06-18
02 Safety Instructions CS14C Ed.0
Depressurize the hydraulic system before
performing maintenance on the hydraulic equipment.
Never replace high pressure hoses with hoses of
lower quality than the original or with hoses that
Pressure settings are always performed on a
Pressure settings must only be performed by trained
before you modify the machine.
During service and maintenance work, all
components that may be brought into motion or fall
must be supported or tied secure.
Do not do any welding on the equipment without
Substances are formed when the paint is heated which
Welding, grinding and other hot work involving
paint being heated must only be carried out where
sufficient ventilation can be used.
protection, eye protection and gloves.
Make sure the engine is turned off before all
maintenance work and before refueling
Be careful when draining hot oil and fluids
Do not handle flammable fluids in the vicinity of hot
surfaces, sparks or naked flames.
Discarded accumulators must be rendered
punctured must be treated like a pressure vessel.
Take care when evacuating the accumulator.
Only authorized electricians may carry out work on
Only qualified electricians should perform any
electrical troubleshooting or maintenance. Remove
all watches and rings that could contact live
Make sure all power to the system has been cut
before carrying out any maintenance work.
under direct control of qualified electrician.
Do not use the cabinets as a toolbox or spare
parts storage container. The inherent vibration and
magnetism associated with transformer and motor
starters can cause inadvertent contact of foreign
objects with live circuits.
Some electrical components may have power when
the main circuit breaker is open, verify that power is
disconnected before servicing.
Do not tamper with safety interlock circuits, safety
guards or other safety devices, except as required
during normal maintenance and troubleshooting.
Confirm that all safety devices and circuits are
replaced and functioning before operation is
Shut of electrical power while making or breaking
Hydraulic oil can cause eczema when it comes in
To Next Page
Loading...
