Need help?Do you have a question about the Atlas Copco GA18 and is the answer not in the manual?
General| Model | GA18 |
|---|---|
| Category | Air Compressor |
| Cooling System | Air-cooled |
| Drive Type | Direct Drive |
| Max Working Pressure | 13 bar |
| Working Pressure Range | 7.5 - 13 bar |
| Tank Capacity | Not applicable |
| Sound Level Range | 67 - 69 dB(A) |
Directives for safe installation of compressors and air dryers, emphasizing specific safety rules.
Explains automatic control, compressor protection, and restart after voltage failure.
Identifies and describes the buttons and indicators on the Elektronikon I control panel.
Explains the meaning of various pictographs displayed on the regulator screen.
Describes the initial screen displayed when the voltage is switched on.
Details shut-down warnings related to high compressor element outlet temperature.
Describes shut-down warnings for high dewpoint temperature in FF compressors.
Explains shut-down due to high compressor element outlet temperature.
Describes the shut-down condition caused by motor overload.
Explains how to navigate through different screens using arrow keys.
Table detailing minimum, nominal, and maximum unloading/loading pressures.
Details settings for element outlet temperature warning and shut-down.
States the nominal warning setting for dewpoint temperature.
Specifies the nominal setting for the service timer.
Overview of automatic control and protection functions for Elektronikon II regulator.
Covers shut-down, warning conditions, and service warnings for Elektronikon II.
Description of all LEDs, buttons, and keys on the control panel.
Describes the functions of different menu options like Main screen, Status data, Measured data.
Explains the main screen display and navigation.
Explains the display when a shut-down condition occurs.
Procedure to set distinct loading and unloading pressure bands.
Procedure to adjust compressor element outlet temperature and warning settings.
Guide to programming timed start/stop and pressure band commands for the compressor.
Procedure to set local, remote, or LAN control modes for the compressor.
Table detailing minimum, nominal, and maximum values for programmable parameters.
Details protection settings like temperature limits, pressure differences, and delays.
Defines service plan intervals and the associated service actions required.
To Next Page
