16
Pionjär 120/120AV 130/130AV
© 2005 Atlas Copco Construction Tools AB
|
No 9800 0438 51
|
2005-10-31
Safety and operating instructions
Carefully let the cover rotate in order to release the
spring tension. Remove the old starter cord.
Fit the new starter cord.
Check the gasket between the fuel tank cover and
the protective cover.
Oil the starter pulley’s needle bearing.
The starter spring should be fixed in the starter
pulley when fitting the starter pulley and the
protective cover.
2.
3.
4.
5.
6.
Wind all of the cord on to the starter pulley.
Pre-tension the starter spring by turning the pulley
clockwise by approx. 360° relative to the cover
before mounting the assembly.
Pull the starter handle carefully in order to locate
the cover correctly.
Fit and tighten the nuts for the protective cover.
7.
8.
9.
10.
Crowder Supply Co., Inc. • 8495 Roslyn St., Commerce City, CO 80022 • Toll Free: 888-883-5144 • www.CrowderSupply.com
www.CrowderSupply.com • Toll Free: 888-883-5144
To Next Page
Loading...
