Atlas Copco QAC 1100 Sd - Generator Application Descriptions (Single Generator); Application Modes for Single Generator

- 32 -
Description of the applications
Electrical installations with only 1 generator
(*) A power transducer is a device that measures the real power of the mains current and converts it intoa 4 - 20 mA signal for the
Qc4002™ MkII module.For further information, contact Atlas Copco.
Type of application Mode Comments
SEMI-AUTO mode
Local start
AUTO mode
Remote start
(SEMI-AUTO mode) The AMF operation will not run correctly!
AUTO mode
Emergency start at mains current failure
SEMI-AUTO mode Only as Power Transducer (*)
AUTO mode Only as Power Transducer (*)
SEMI-AUTO mode
AUTO mode
SEMI-AUTO mode Only as Power Transducer (*)
AUTO mode Only as Power Transducer (*)
SEMI-AUTO mode Only as Power Transducer (*)
AUTO mode Only as Power Transducer (*)
Transformer maintenance SEMI-AUTO mode Only as transformer maintenance box
Exporting network power
Island operation
AMF operation
Peak distribution
Fixed power
Load take over