- 38 -
The recommendation of the engine manufacturer regarding the use of biodiesel is "B5" classification (which consists in 5% biodiesel and 95% diesel
from conventional petroleum).The use of biodiesel out from the specification recommended in this manual may cause damage to the
engine fuel system and voids the product warranty.
500h 1000h 2000h
Quartely Annually Bi-annually
ENGINE
Inspect the coolant fluid (2) (3) XXXX
Replace coolant fluid (2) X
Inspect alternator (2) X
Inspect starter (2) X
Inspect turbocharger (if fitted) – (2) X
Inspect water pump (2) X
UNIT
Check general condition (damaged parts, loose nuts and bolts, problems in previous operations, color of
the exhaust gases)
XXXX
Check the oil, water and fuel level before starting and during operation X X X X
Clean the dust collector of air filters before starting X X X X
Replace the air filter elements (1) XX
Externally clean the unit (1) XXX
Lubricate door hinges, clamps, towing bar eye and moving parts (1) X X X
Check for possible leaks of fuel oil, lube oil and coolant fluid X X X X
Internally clean the fuel tank (1) (4) XX
Check battery and terminals XXX
Check protection devices (1) XX
Clean the drain separator element (where fitted) (5) XXX
Inspection performed by a technician from Atlas Copco XX
Notes:
1. More often when the compressor operates in an environment with excessive suspended particles.
2. Refer to the operation and maintenance instruction manual for the engine or alternator.
3. Check additive concentration every 500 hours of operation.Change the coolant fluidevery 2000 hours of operation.
4. Replace fuel filters regularly. Glued or clogged filters cause bottlenecks in the passage of fuel and reduce engine
performance. Replacement frequency depends on fuel quality.
5. Refer to the instruction manual for the generator.
Daily
INTERVALS
Activies
To Next Page
Loading...
