Atlas Copco QAS 200 VoD S3A ESF - Controller; Control Panel with Qc2103 Controller

- 23 -
S2 ....... Emergency stop button
Push the button to stop the generator in case
of an emergency. When the button is
pressed, it must be unlocked, before the
generator can be restarted. The emergency
stop button can be secured in the locked
position with the key, to avoid unauthorized
use.
S20 ..... ON/OFF switch
Position O: No voltage is supplied to the
Qc1103™ module, the generator will not
start.
Position I: Voltage is supplied to the
Qc1103™ module, it is possible to start up
the generator.
X25 .....Terminal strip
2.4.1.4 Control panel with Qc2103™
controller
A1 .......Qc2103™ display
F10......Thermal circuit breaker
The thermal circuit breaker trips when the
current from the battery to the engine control
circuit exceeds its setting. It can be reset by
pushing the button.
S2........Emergency stop button
Push the button to stop the generator in case
of an emergency. When the button is
pressed, it must be unlocked, before the
generator can be restarted. The emergency
stop button can be secured in the locked
position with the key, to avoid unauthorized
use.
S20......ON/OFF switch
Position O: No voltage is supplied to the
Qc2103™ module, the generator will not
start.
Position I: Voltage is supplied to the
Qc2103™ module, it is possible to start up
the generator.
X25 .....Terminal strip
S20
F10
S2
X25
A1