INSTRUCTION MANUAL
21
4.3 LUBRICATION OILS
It is strongly recommended to use Atlas Copco branded
lubrication oils for both compressor and engine.
Mineral compressor oil PAROIL M:
for use in normal conditions.
- 5 liter can : order number 1615 5947 00
- 20 liter can : order number 1615 5948 00
- 208 liter barrel : order number 1615 5949 00
Mineral engine oil PAROIL SAE 15 W 40:
for use in normal conditions.
- 5 liter can : order number 1615 5953 00
- 20 liter can : order number 1615 5954 00
- 208 liter barrel : order number 1615 5955 00
Synthetic compressor oil PAROIL S:
for use in ambient temp. below -10° C.
- 5 liter can : order number 1615 5950 00
- 19 liter can : order number 1615 5951 00
- 208 liter barrel : order number 1615 5952 00
Never mix synthetic with mineral oil.
If you want to use another brand of oil, consult
Atlas Copco for more information concerning the
recommended oil and service intervals.
4.4 OIL LEVEL CHECK
Never mix oils of different brands or types
Use only non-toxic oils where there is a risk of
inhaling delivered air
4.4.1 CHECK ENGINE OIL LEVEL
Consult also the Engine Operation Manual for the oil
specifications, viscosity recommendations and oil change
intervals.
See schedule.
Check engine oil level according to the instructions in the
Engine Operation Manual and top up with oil if necessary.
4.4.2 CHECK COMPRESSOR OIL LEVEL
Fig. 4.1 Check compressor oil level
Stop the compressor. Let the oil settle for a few minutes.
With the unit standing level, check the level of the compressor
oil.
The pointer of the oil level gauge (1) must register in the upper
extremity of the green range. Add oil if necessary.
Before removing oil filler plug (2), ensure that the
pressure is released by opening an air outlet valve
(3).
After topping up with oil, reinstall and tighten the filler plug.
☞
To Next Page
Loading...
