- 32 -
AUTOMATIC FUNCTIONS
Auto Start
The compressor can be automatically started when the
monitored pressure drops under the specified level with
the Auto Start function.
Auto No-Load
The Auto No-Load function can be used to save fuel when
there’s no air demand from the application. The
compressor reverts to No-Load operation when no air
demand is present for a pre-configured period of time.
Auto Load
The compressor starts to deliver air as soon as it can, with
the Auto Load function.
Auto Re-Load
The compressor will start loading itself as soon as there is
air demand by the application with the Auto Re-Load
function.
Auto Stop
This function stops the engine when no air demand is
present for a pre-configured period of time. Fuel savings
can be achieved by using this function.
- These functions can be configured according to the needs
of the application.
- These functions may require an Atlas Copco Service Key
to be accessible.
- Contact Atlas Copco Technical Support for assistance in
setting up a machine with Automatic Functions.
To Next Page
Loading...