- 50 -
Change Display Settings
Press the SETTINGS VIEW button
• scroll to ‘1000 GENERAL SETTINGS’
• press ENTER
• scroll to ‘1310 DISPLAY BACKLIGHT’
• ENTER the DISPLAY BACKLIGHT menu
• scroll to the setting you would like to change
• press ENTER.
To change a setting, the red figure is editable.
Scroll up/down and press ENTER to change. Use left/
right to shift between editable figure.
Now press BACK until you’re back in the Main View
(or in the menu you require).
Go To Diagnostics
Press the SETTINGS VIEW button
• scroll to ‘1000 GENERAL SETTINGS’
• press ENTER
• scroll to ‘1150 DIAGNOSTICS’
• ENTER the Diagnostics menu,
• ENTER the ‘ENABLE’ parameter
• scroll to ‘ON’ and press ENTER.
Now the ECU will get PAC (ignition) and one can
perform ECU diagnostics (read DM1 List, DM2 List,
ECU values, perform engine diagnostics, …).
Now press BACK until you’re back in the Main View
(or in the menu you require).
To leave Diagnostics, press the STOP button.
To Next Page
Loading...
