13
EDITOR PARAMETER SETTINGS CONTINUED...
BOOST
BST: Simply double click the BST button to turn the boost on/off. Greyed out is off,
while yellow is on.
MODE: Select from the following BOOST modes:
OVERDRIVE: Models a classic overdrive pedal similar to the Boss SD-1
SCREAMER: Models a classic overdrive pedal similar to the Ibanez TS-808
DISTORTION: Models a typical distortion pedal similar to a Boss DS-1
FUZZ: Models a fuzz-type distortion pedal similar to a Fuzz-Face
CLEAN BOOST: Models a traditional clean boost drive pedal
DRIVE (0-100%): Adjusts the drive of the boost effect from 0% to 100%.
TONE (0-100%): Adjusts the variable tone of the boost effect from 0% to 100%. Set
low for darker tones and higher for brighter tones.
LEVEL (dB): Adjusts the output level of the boost effect. Can be set to match the
bypassed level or to just provide additional boost or cut.
AMP
MODEL: There is a window that displays the currently selected amp model. Click on
this window and a list of available amps will be displayed. Click on one to load it.
AMP: Simply double click the AMP button to turn the amp on/off. Greyed out is off,
while red is on.
GAIN: Sets the gain control knob of the amplifier from 0.0 (minimum) to 10.0
(maximum).
BASS: Sets the bass control knob of the amplifier tone stack from 0.0 (minimum) to
10.0 (maximum).
MIDS: Sets the mids control knob of the amplifier tone stack from 0.0 (minimum) to
10.0 (maximum).
TREBLE: Sets the treble control knob of the amplifier tone stack from 0.0 (minimum)
to 10.0 (maximum).
PRESENCE: Sets the presence control knob of the power amplifier from 0.0
(minimum) to 10.0 (maximum).
MASTER: Sets the master volume control knob of the power amplifier from 0.0
(minimum) to 10.0 (maximum).
LEVEL (dB): Adjusts the final output level of the amp model. This control helps to
match the level of your preset with other presets.
DAMPING: Adjusts the damping factor of the power amp model from 0% to 100%.
Lowering the damping results in more bass resonance and more presence.
To Next Page
Loading...