9
DESCRIPTIONS
• The GATE effect provides a programmable NOISE SUPPRESSOR, EXPANDER,
and GATE. NOISE GATE enable is programmed per preset, so that you can shut it
off for particular presets, and leave it on for others. These options can be set in
the GATE effect menu.
• The COMP effect models a compressor module for controlling the dynamics of
your guitar input. The COMPRESSOR options can be set in the COMPRESSOR
effect menu.
• The BOOST effect models classic stomp box distortion effects. It is placed
toward the beginning of the signal chain to drive the front end of the amp model
and tighten the tone.
• The EQ block is made up of one dedicated Pre EQ and three (3) PARAMETRIC EQ
effect modules, each of which can be placed in the PRE or POST the amp block.
• The RVB effect models five different reverb types for adding ambience to your
guitar tone. Three sizes of hall reverb and two different spring reverbs.
CABINET MODELING
The CABINET section is where AMPLIFIRE-BOX applies Impulse Response (IR)
modeling technology and filtering to simulate the sound of real-life speakers and
guitar cabinets as recorded by specific microphones . Each of the amp models in
AMPLIFIRE-BOX contain a specific IR cabinet, but you can upload any .wav IR file to
your AMPLIFIRE-BOX preets via USB.
• The CABINET modeler lets you tweak the cab models with filters specially
designed for adjusting microphone and loudspeaker cabinet tones.
• The CABINET modeler can be enabled or disabled on both the 1/4” and XLR
outputs independently allowing you to use full range systems AND other real
guitar cabinets simultaneously.
NOTE: One of our unique features is that IRs are embedded in user presets so that
the preset is completely portable. Any imported or exported presets carry the IR data
with them so you get the exact tone you need.
To Next Page
Loading...