18
PARAMETER SETTINGS CONTINUED...
CABINET
CAB: Simply double click the CAB button to turn the cabinet model on/off. Greyed out
is off, while orange is on.
UPLOADING CAB IR FILES: There is a window that displays the cabinet type used
in the current preset. Click on this window and you can select an IR file from your
personal library that you have purchased or created. The newly loaded IR file will
automatically be saved with your preset.
ROLLOFF (kHz): Adjusts a high frequency rolloff filter corner frequency to help tame
cabinet impulses that have too much high end. Adjust down to cut off more highs or
adjust up for less rolloff.
PEAK Q: Adjust the peaking of the rolloff filter. The peak is a bump in the frequency
response just before rolloff. A lower value of PEAK Q means less peak. Smooth (no
peak) values are between 0.5 and 1.0. High peaking values are between 1.0 and 5.0.
BOTTOM (dB): Adjust the bottom end shelf of the cabinet model. Use this to reduce
cabinet models with too much low end woof or increase to warm up cabinets that
sound too thin.
AIR (dB): Adjust the upper top end frequencies of the cabinet model. Use to add more
sparkle and brilliance to cabinet models that sound too dull or dark.
LEVEL (dB): Adjust the output level of the cabinet model. Some impulses have a
different perceived loudness than others. Use this parameter to help balance the level
of a cabinet model with your amp model.
To Next Page
Loading...