ATOMSTACK A10 Pro Installation Manual

Part 6：Instructions for use of the display
LaserGRBL exports nc
format, Lightburn exports
gc format
Insert SD card
Click Cavre to
enter the SD card
file list
Press the power
button to enter the
home page of the
display
Select the file to be
engraved and move
the laser to the position
to be engraved
Laser fixed focus
method: use a fixed
focus lens below the
laser to determine the
focal length
Select the number of
times you want to
engrave/cut, start
engraving/cutting
Click the position
button to determine
the origin of the laser
Finish carving
Click the frame button
to confirm the
engraving range
Click the
button to start carving
During the engraving
process, the engraving
speed and energy can
be adjusted. If there is
an abnormal situation,
you can press the pause
or stop function key

ATOMSTACK A10 Pro Specifications

General

Laser Power	10W
Laser Wavelength	455nm
Connectivity	USB
Engraving Accuracy	0.01mm
Output Voltage	12V
Engraving Area	410mm x 400mm
Material Compatibility	Wood, Plastic, Leather
Control Software	LaserGRBL
Laser Protective Cover	Yes
Input Format	BMP, JPG, PNG, DXF
Power Supply	AC 100-240V, 50/60Hz
Focusing Method	Fixed focus laser, no need to adjust focus before engraving