ATOMSTACK A10 Pro Installation Manual

Y
X
Y-axis
limiter
TIPS：How to determine the tightness of eccentric nuts?
Under the condition of ensuring that the bracket does not shake, you can lift one
end of the machine to an angle of 45 degrees with the horizontal plane, and release
the X-axis or Y-axis bracket from a high place. If the bracket can slide at a constant
speed to the end, the tightness is suitable.
S t e p 5
Use a wrench to
turn the eccentric
nut to adjust the
tightness of the
guide wheel and
the guide rail
Partial
enlarged
view
1
3
S t e p 6
S t e p 7
Installation Manual:
1. As shown in the picture, place the cutting pad under the
engraved/cut object
2. As shown in the figure, the cutting pad should be placed to
cover the working area as far as possible

ATOMSTACK A10 Pro Specifications

General

Laser Power	10W
Laser Wavelength	455nm
Connectivity	USB
Engraving Accuracy	0.01mm
Output Voltage	12V
Engraving Area	410mm x 400mm
Material Compatibility	Wood, Plastic, Leather
Control Software	LaserGRBL
Laser Protective Cover	Yes
Input Format	BMP, JPG, PNG, DXF
Power Supply	AC 100-240V, 50/60Hz
Focusing Method	Fixed focus laser, no need to adjust focus before engraving