IMEO2 - User manual012
CONNECTION STANDARDS
First time use:
The remote control has a pre-installed lithium CR2025 battery. Remove the protective tab to activate the remote control
batter y.
Replace the remote control battery:
The remote control requires a CR2025, 3V Lithium battery.
To replace this battery, follow the steps as below:
• Push the tab on the side of the battery tray towards the tray
• Slide the battery tray out of the remote control
• R e m o v e t h e o l d b a t t e r y . P l a c e a n e w C R 2 0 2 5 b a t t e r y i n t o t h e b a t t e r y t r a y w i t h t h e c o r r e c t p o l a r i t y a s i n d i c a t e d
• Slide the battery tray back into the slot in the remote control
4
3
1
2
4
CAUTION
If the remote control is operated near other products which generate infrared rays,or if other remote control units also using
infrared rays are near the unit, it may operate incorrectly. Conversely, the other products may operate incorrectly
Precautions Concerning Batteries:
- Then the remote control is not to be used for a long time (more than a month), remove the battery from the
Remote Control to prevent it from leaking.
- If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with new
ones.
- Do not use any batteries other than those specied.
- Do not heat or disassemble batteries.
- Never throw them in re or water.
- Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short circuit, leak
or explode.
- Never recharge a battery unless it is conrmed to be a rechargeable type.