IMEO2 - User manual 017
Chapter 5
Additional information
In projects with public system access such as classrooms or conference rooms, it can be desirable to lock it in a specic
operation (input) mode or disable specic functions, to avoid users changing the input signal.
Lock input:
To lock the sound bar in a specic input function (disable the operation mode selection), turn the unit ON and switch to the
desired audio source (e.g. AUX input). Press and hold the ‘AUX’ button (or other selected function) on the remote control
for about 5 seconds to enable the lock. All status indicator LED’s will blink now simultaneous and the input selection will be
locked. (the input can’t be changed by the user). Press and hold the selected function button again for about 5 seconds to
disable the lock. All status indicator LED’s will blink again simultaneous and the lock will be disabled.
Disable Bluetooth:
To disable the Bluetooth function, make sure the unit is in standby mode and press and hold the BT button on the remote
control for about 5 seconds. The blue Bluetooth indicator LED will blink and the Bluetooth function will be disabled.
Press and hold the BT button again for about 5 seconds in standby mode to enable the Bluetooth function again. The blue
Bluetooth indicator LED will blink and the Bluetooth function will be enabled again.
Disable auto standby:
To disable the auto standby function, make sure the unit is in standby mode and press and hold the power button on the
remote control for about 5 seconds. The green indicator LED will ash 3 times and the auto standby function will be disabled.
To enable the auto standby function, make sure the unit is in standby mode and press and hold the power button on the
remote control for about 5 seconds. The red indicator LED will ash 3 times and the auto standby function will be disabled.
Disable volume control on main unit:
To disable the volume control on the main unit, make sure the unit is in standby mode and press and hold ”VOL+” and “VOL-”
buttons on main unit. The green indicator LED will ash 3 times and the volume control will be disabled.
To enable the volume control on the main unit, make sure the unit is in standby mode and press and hold ”VOL+” and “VOL-”
buttons on main unit. The red indicator LED will ash 3 times and the volume control will be enabled.
Before updating the IMEO2, the new software must be obtained. This software can be found at https://
audac.eu/software. The downloaded files, ending in .bfu, must be copied exactly to a USB stick.
Before the update can be carried out, the IMEO2 has to be switched to USB mode. The USB stick can be inserted
into the USB port and the update will start automatically. All the lights will be on during the update process.
When the update is completed the IMEO2 will automatically enter standby mode. The IMEO2 is now updated.
DISABLE / ENABLE SPECIFIC FUNCTIONS
UPDATE
To Next Page
Loading...
Need help?
General
