IMEO2 - User manual018
In installations with multiple IMEO2’s installed throughout the building, it can be desirable to assign custom Bluetooth ID’s to distinguish
them from each other. Typical applications are hotels, conference rooms, schools, ... The hotel mode function in the rmware offers
a solution for these applications.
Using the hotel mode, the Bluetooth ID can be adjusted to ‘AUDAC - IMEO2 + xxxx’ where ‘xxxx’ is a 4-digit number, representing
the room number, class number, meeting room number, ...
Additionally, a function is implemented to dene a specic wake-up source, allowing the IMEO2 to always turn-on with the same input
source selected, no matter which input source was selected before power-down.
To enable hotel mode, follow below steps:
Enable hotel mode:
Switch IMEO2 to standby mode (upper RED LED illuminated)
Press code ‘6280’ on remote control to enable hotel mode. (see image as below)
(6280 = COAXIAL – BT – PAIR – VOL-)
The green LED will start to blink (others are off)
Enter the rst number of the 4-digit ID (see image as below)
The blue LED will start to blink (others are off)
Enter the second number of the 4-digit ID (see image as below)
The orange LED will start to blink (others are off)
Enter the third number of the 4-digit ID (see image as below)
The white LED will start to blink (others are off)
Enter the fourth number of the 4-digit ID (see image as below)
After the 4 digits of the Bluetooth ID are entered, the upper (standby) LED will start to blink.
Now the wake-up input source can be selected with the last digit:
1: AUX
3: HDMI ARC
0: No specic wake up source
Disable hotel mode:
HOTEL MODE
•
•
•
•
•
•
•
•
•
•
•
•
•
The BT name will now be changed to e.g. ‘AUDAC IMEO2 – 1234’ (in case 1234 was
entered)
To exit the hotel mode function,switch to standby mode and press the code ‘0826’ on
the remote control.
The red LED will ash 3 times.
USB
1
4
7
2
5
8
0
3
6
9
To Next Page
Loading...
Need help?
General
