IMEO2 - User manual016
Using the AUX socket
The AUX socket allows connection of the sound bar to any
device with an unbalanced stereo line output, such as TV,
computer, laptop, smartphone, tablet, ...
Depending of the output of the connected device 3.5 mm
jack (A) or RCA (B), the appropriate cable shall be used.
SERV ICE ON LY
HDMI AR C
OPTICALCOAXIAL AUX
SERV ICE ON LY
HDMI AR C
OPTICALCOAXIAL AUX
SERV ICE ON LY
HDMI AR C
OPTICALCOAXIAL AUX
A
B
Using Bluetooth
The rst time when your Bluetooth portable device is connected (smartphone, tablet, ...) it needs to get paired. For getting it
paired, the sound bar shall be switched ON and in Bluetooth mode. This can be done using the power button on the side of
the unit, or the remote control. When in Bluetooth mode, the blue LED behind the front grill will blink. Activate the Bluetooth
mode in your portable device and search for devices. The device name ‘AUDAC IMEO2’ will appear on your Bluetooth device
list. If the device can’t be found, press and hold the button on the remote control to be discoverable. The system
will enter in pairing mode and two ‘beeps’ will be heard through the speakers. The Bluetooth indicator (blue LED) will blink
fast. Select ‘AUDAC IMEO2’ from the device list and an ‘uplifting beep’ will be heard through the speakers. The Bluetooth
indicator (blue LED) will illuminate constantly.
BLUETOOTH
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. We are the licensee to use
such marks. Other trademarks and trade names are those of their respective owners
NOTE
The operation range between the sound bar device and the Bluetooth transmitter (smartphone, tablet, ... ) is
approximately 8 meters. (without any object in between)
Before any Bluetooth device is connected, ensure you know its capabilities
Compatibility with all Bluetooth devices is not guaranteed
Any obstacle in between the sound bar and the Bluetooth transmitter can reducethe operational range
If the signal strength is weak, the sound bar will disconnect automatically, but will re-enter pairing mode automatically.
•
•
•
•
•
/ / PPAIRAIR
To Next Page
Loading...
Need help?
General
