AUDAC MFA208 - Chapter 6: Additional information; Technical specifications

29
Chapter 6
Additional information
Technical specifications
Output power MFA208 @ 4Ω Stereo 2 x 40 Watt
(1 kHz, THD 1%) @ 8Ω Stereo 2 x 40 Watt
@ 16Ω Stereo 2 x 40 Watt
@ 70/100V Bridged 1 x 80 Watt
MFA216 @ 4Ω Stereo 2 x 80 Watt
@ 8Ω Stereo 2 x 80 Watt
@ 16Ω Stereo 2 x 80 Watt
@ 70/100V Bridged 1 x 160 Watt
NOTE: The powers shown for low impedance stereo mode may look strange to be equal for 4Ω, 8Ω and 16Ω loads, however these figures are true
and correct. The output voltage is increased at higher load impedances to guarantee the maximum output power is achieved. These figures are
depending of a correct output setting configuration in the ‘Settings’ > ‘Amplifier’ > ‘Output’ and ‘Output type’ menu.
Inputs Mic in Type Balanced microphone (or mono line)
Connector 3-pin terminal block ~ 3.81 pitch
Sensitivity 0 dB ~ -50 dBV
Other Phantom power (15V DC)
Priority
Line in Type Unbalanced stereo line
Connector RCA (2x)
Sensitivity +4 dB ~ -20 dBV
Front line input Type Unbalanced stereo line
Combined with Line in (RCA)
Connector 3.5 mm stereo jack
Module Type SourceCon™ interface card slot (1x)
Priority mute contact Type Priority mute
2-pin terminal block ~ 5.08 mm pitch
Controls Front panel
RS-232
RS-485
TCP/IP
AUDAC Touch™ 2
Outputs Loudspeaker Type Loudspeaker output connection
Connector 4-pin terminal block ~ 5.08 pitch
Line out Type Line-out connection
Connector 3.5 mm stereo jack