Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connector -2-.
– Loosen the hose clamps -1-, then clamp off the coolant hoses
with the -3094- and then remove them.
– Remove the nuts -arrows- and then remove the Transmission
Coolant Valve - N488- .
Installing
Install in reverse order of removal and note the following:
• Secure all hose connections with hose clamps that match the
ones used in series production. Refer to the Parts Catalog.
– Check the coolant level. Refer to ⇒ page 99 .
Tightening Specifications
♦ Refer to ⇒ “2.4 Overview - Coolant Valves”, page 103
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
110 Rep. Gr.19 - Cooling System
To Next Page
Loading...
