Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connector -1- for the Charge Air Pressure Sen‐
sor - G31- .
– Loosen the screw-type clamp -2- and remove the air duct pipe
from the Throttle Valve Control Module - GX3- .
– Place the container of the -VAS5014- or the -VAS6208- un‐
derneath.
– Lift the clamp -2- and remove the coolant hose from the lower
right of the radiator and drain the coolant.
– Loosen the left front wheel housing liner in the front area and
push slightly toward the rear. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Wheel Housing Liner; Overview - Front Wheel Hous‐
ing Liner .
– Loosen the hose clamp -1- and remove the air duct hose and
remove downward.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Engine, Removing and Installing 7
To Next Page
Loading...
