Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
CAUTION
Risk of Destroying a Used Ribbed Belt by Reversing the Run‐
ning Direction
– Mark the running direction before removal.
– Pay attention to the running direction when reinstalling.
– Pivot the tensioner counter-clockwise in direction of -arrow-
and remove the ribbed belt from the A/C compressor ribbed
belt pulley.
– Secure the tensioner using the -T10060A- .
– Remove the A/C compressor from the bracket. Refer to ⇒
Heating, Ventilation and Air Conditioning; Rep. Gr. 87 ; A/C
Compressor; A/C Compressor, Removing and Installing at
Bracket .
– Remove the left and right bolt -1- for the support bearing -2-.
– Remove the bolt -arrow- and remove the wiring duct -1- from
the oil pan upper section toward the front and push it down‐
ward.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
8 Rep. Gr.10 - Engine Assembly
To Next Page
Loading...
