Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Continuation for All Vehicles:
– Remove the connector -2- from the bracket and disconnect it.
– Disconnect the connector -1- from the engine control module.
– Free up the wiring harness and place it on the engine.
– Disconnect the connector -arrow- for the starter generator.
– Release the retainer in direction of -arrow- and remove the
vacuum hose -1-.
Vehicle with Manual Transmission:
– Remove -2 to 5- that are accessible from above that connect
the engine to the transmission.
– Remove the starter slightly from the transmission and leave it
in the installation position.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Engine, Removing and Installing 29
To Next Page
Loading...
