Audi A6 2016 - Page 96

Audi active lane assist
Switching on and off
Applies to vehicles: with Audi active lane assist
Fig. 99 Turn s ignal lever : act ive lane assist butto n
Fig. 100 Windsh ield: camera window for active lane assist
• Press the c::> fig. 99 button to switch the system
on and off . The . or
ra, ind icator light in the
instrument cluster turns on or off .
Indicator lights
• Ready:
The indicator light turns on when the
system is ready for use . The system can now be
operated .
• Not ready: The indicator light turns on if the
system is switched on but is inoperab le. This may
be due to the following reasons:
- The re is no lane marker line.
- The relevant lane marker lines are not detected
(for example, markings in a construction zone
or because they are obstructed by snow, dirt,
water or backlighting).
- The vehicle's speed is below the speed needed
to activate it, which is about 40 mph (65 km/
h).
- The lane is narrower than about 8 ft. (2.5 m) or
wider than 15 ft (4.5 m).
- The curve is too sharp.
94
- The driver's hands are not on the steering
wheel.
(1) Tips
Make sure the camera's field of view
¢ fig.
100 is not obstructed by stickers or any-
thing else . For information on cleaning, refer
to
¢ page 203 .
Lane assist display in the instrument
cluster
Applies to vehicles: wit h Audi act ive la ne ass ist
Fig. 101 Instrument cluster: act ive lane ass ist is switched
on and providing warn ings
Fig. 102 Instrument cluste r: active lane assist is switched
on but not ready to provide warnings
You can call up the active lane ass ist display us-
ing the buttons in the multifunction steering
wheel
c::> page 23.
An additional indicator appears in the Head-up
display *.