Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Caution:
Take care not to damage cast joints and extruded sections on
separation.
2.1.2 Replacement part
♦ Wheel housing - front section
Preparing new parts
– Transfer separating cut to longitudinal member and cut off
hatched area.
2.1.3 Welding in
– Prepare flanges on body and new parts for welding.
– Fix new part in position with alignment bracket.
– Weld front longitudinal member to cast joint: SG continuous
seam.
– Weld strut holder to mount, SG continuous seam.
– Weld strut holder to plenum chamber, SG continuous seam.
Audi A8 1994 ➤
Body repairs - Edition 10.1998
32 Rep. Gr.50 - Body - front
To Next Page
Loading...
