Audi A8 1994 - Page 75

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Rear cross panel to luggage compartment floor, clinching
points.
– Detach part.
2.1.2 Replacement parts
Rear cross panel/side panel
Solid rivets
Pop rivets
Body - adhesive
2.1.3 Riveting in
Preparing new parts
– Transfer separating cuts to new parts.
– Joddle-join new part.
– Fit rear cross panel and fix in place.
– Drill overlap area, 4 x ∅ 2.5 mm.
– Drill rear cross panel with side panel, ∅ 2.5 mm.
– Detach part.
– Countersink holes in all parts.
– Prepare joints for bonding.
– Apply adhesive.
Note:
Refer to General notes on bonding.
– Fit rear cross panel and fix in position.
– Punch holes in rear cross panel with luggage compartment
panel.
Note:
Use clamps.
Audi A8 1994 ➤
Body repairs - Edition 10.1998
2. Rear cross panel/side panel - Partial renewal 71