Audi A8 2003 - Removing and installing centre console without extension

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2.7 12-cyl. petrol engine 6.0 ltr. MPI
Procedure for removing:
– Carefully pull rear and centre parts of engine cover panel off
retaining pins one after another in direction of -arrows 1-.
– Pull front part of engine cover panel off intake manifold in di‐
rection of -arrows 2- and remove.
Procedure for installing:
– Position engine cover panels on retaining pins and then use
your hands to press it onto retaining pins, one after the other.
2.2.8 6-cyl. diesel engine 3.0 ltr. TDI
Procedure for removing:
– Carefully pull engine cover panel off retaining pins one after
another -arrows-.
Procedure for installing:
– Position engine cover panel on retaining pins and then use
your hands to press it onto retaining pins, one after the other.
2.2.9 8-cyl. diesel engine 4.0 ltr. TDI
Procedure for removing:
– Carefully pull engine cover panel off retaining pins at points
-1- and -2-.
Procedure for installing:
– Position engine cover panel on retaining pins and then use
your hands to press it onto retaining pins, one after the other.
Audi A8 2003 ➤
Maintenance - Edition 06.2014
12 2. Preparations