Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Fitting location of continued coolant circulation pump -V51-
♦ At front left of engine
Removing and installing ⇒ Rep. gr. 19
Fitting location of engine speed sender -G28-
2 - Electrical connector for engine speed sender -G28-
Fitting location of secondary air inlet valves and intake manifold
flap valve -N316-
♦ At rear of supercharger with charge air cooler
1 - Secondary air inlet valve -N112-
2 - Intake manifold flap valve -N316-
3 - Secondary air inlet valve 2 -N320-
Fitting location of secondary air pump motor -V101-
♦ In engine compartment (front left)
Removing and installing ⇒ Rep. gr. 26
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2. Injection system 15
To Next Page
Loading...
