Audi A8 2010 - Page 28

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Intake air temperature sender -G42- / intake manifold pressure
sender -G71- - tightening torque
– Tighten bolts -arrows- to 10 Nm.
Intake manifold (bottom section) - tightening torque
– Tighten bolts and nuts -arrows- in stages and in diagonal se‐
quence; final torque 9 Nm.
Throttle valve module -J338- - tightening torque
– Tighten bolts -arrows- in diagonal sequence to 10 Nm.
Regulating flap control unit -J808- - tightening torque and se‐
quence
– Tighten bolts in 3 stages as follows:
Stage Bolts Tightening torque
1. -5, 6- Screw in bolts by hand until they make
contact
2. -6- 10 Nm
3. -5- 10 Nm
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
24 Rep. gr.24 - Mixture preparation - injection