Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -1-.
– Remove bolts -arrows- and detach throttle valve module -
J338- with intermediate flange.
Caution
Risk of irreparable damage to engine.
♦ Block off the intake port with a clean cloth to prevent small
items from dropping into the supercharger.
Installing
Installation is carried out in the reverse order; note the following:
• Tightening torque
⇒ Fig. “„ Throttle valve module -J338- - tightening torque““ ,
page 24
Note
♦
Fit new O-rings.
♦
Hose connections and air pipes and hoses must be free of oil
and grease before assembly.
♦
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue .
♦
To secure the air hoses at their connections, spray rust re‐
mover onto the worm thread of the used hose clips before
installing.
– Insert intermediate flange -2- with O-rings into supercharger
-1- -left arrows-.
– Fit throttle valve module -J338- -item 3- on intermediate flange
-right arrows-.
– Tighten bolts -4- for throttle valve module ⇒ page 24 .
– After renewing throttle valve module, perform Adaption in
Guided Functions
mode ⇒ vehicle diagnostic tester .
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
26 Rep. gr.24 - Mixture preparation - injection
To Next Page
Loading...
