Audi A8 2010 - Page 38

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Adapter set -V.A.G 1318/10-12- and adapter -V.A.G 1318/15-
♦ Vehicle diagnostic tester
♦ Fuel-resistant measuring container
Checking fuel pressure
• Battery voltage at least 12.5 V.
• Fuel filter OK.
•
Fuel tank at least
1
/
4
full.
• Fuel pump control unit -J538- OK; checking in Guided Fault
Finding ⇒ vehicle diagnostic tester .
• Ignition off.
– Remove filler cap -arrow- for fuel filler neck.
WARNING
Risk of injury caused by fuel.
♦ To reduce the pressure in the fuel system, wrap a clean
cloth around the connection and carefully loosen the con‐
nection.
– Detach fuel supply hose -1- from high-pressure pump and
move clear -arrow-.
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
34 Rep. gr.24 - Mixture preparation - injection