Audi A8 2010 - Page 39

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Connect K-Jetronic pressure tester -V.A.G 1318- to fuel sup‐
ply hose with adapters -V.A.G 1318/11- and -V.A.G 1318/15- .
– Close cut-off valve on K-Jetronic pressure tester -V.A.G
1318- .
• Lever is at right angle to direction of flow -arrow-.
– Connect a vehicle diagnostic tester.
– Select „Engine electronics“ in vehicle self-diagnosis.
– Then select „Final control diagnosis“.
– Select „Fuel pump electronics“ from list and press „start“.
Note
This function activates the fuel pump.
– Read off fuel pressure on K-Jetronic pressure tester -V.A.G
1318- .
• Specification: 5 to 8 bar
– End this function when fuel pressure stops rising on K-Jetronic
pressure tester -V.A.G 1318- .
– If specification is not attained, check delivery rate of fuel pump
⇒ Rep. gr. 20 .
Checking residual pressure
– Check system for leaks and check residual pressure by watch‐
ing the drop in pressure on the K-Jetronic pressure tester -
V.A.G 1318- .
• After 10 minutes pressure should still be at least 3.0 bar.
If the residual pressure drops below 3.0 bar:
♦ Check union between pressure tester and fuel line for leaks.
♦ Check pressure tester for leaks.
♦ Check fuel lines and their connections for leaks.
♦ Renew fuel filter with integral fuel pressure regulator ⇒ Rep.
gr. 20 .
♦ Renew fuel pump ⇒ Rep. gr. 20 .
Assembling
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
2. Injection system 35