Audi Q8 e-tron 2024 - Page 122

High-voltage system
‘When using the Audi charging system, make sure the power
plug is inserted in the power socket page 126. No power sup-
ply was recognized even though the charging cable is plugged
Illuminated in, Have the power supply or power supply system inspected.
When using the Audi charging system, check the status displays
Yellow on the unit > table on page 127. See an authorized Audi dealer
or authorized Audi Service Facility for assistance if necessary.
The vehicle is not secured from rolling away. Check if “P” is se-
lected and the parking brake is set. If the LED continues to flash,
see an authorized Audi dealer or authorized Audi Service Facility
for assistance.
Flashing
The charging connector may not be able to lock correctly in the
vehicle charging port. Check if the charging connector is insert-
ed correctly. Disconnect the charging connector, reconnect it to
the charging socket, and press it upward lightly for five seconds,
or use a different charging station. If the LED stays turned on,
there is a malfunction either in the vehicle charging system or at
Red Illuminated the power source. See an authorized Audi dealer or authorized
Audi Service Facility for assistance if necessary.
Both charging port doors are open. Try to close one of the
charging port doors by hand. If the LED stays turned on, the
high-voltage battery may not be charging. See an authorized
| Audi dealer or authorized Audi Service Facility for assistance.
[The outside temperature is too low or too high.
— ; > Open the cover in the front compartment on
The charging display modes are also displayed the side with the affected charging port.
in the instrument cluster Ey » Loosen the red loop @) © fig. 87 from the re-
tainer and then pull on the loop carefully >@.
> If necessary, open the charging port door by
hand.
> After releasing manually, secure the loop on
the retainer and close the cover.
> Drive to an authorized Audi dealer or author-
ized Audi Service Facility immediately to have
the malfunction corrected.
Manually releasing the charging connector
If you are not able to pull the charging connector
out of the vehicle charging port, there may be a
malfunction. You must use the manual release to
release the vehicle charging connector.
Fig. 87 Front compartment: emergency release
Manually releasing the charging port door
Requirement: the “P” selector lever position
must be selected and the vehicle must be un-
locked.
In case of malfunction, you can manually release
the charging port door.
120
OwnersManuals2.com