Audi Q8 e-tron 2024 - Page 125

4K40127218A
High-voltage system
> To turn ona timer, press CD @.
» To use an active timer for the next charging
process, select timer charging mode ©
© page 121. A colored bar in the button will
light up when timer charging mode is active.
You can turn on multiple timers at the same
time. The timer that is currently active will be in-
dicated with a number G).
If the departure time set for the timer: @® is too
soon, the desired charging target may not be
reached.
Itis not possible to charge using the timer at
some charging stations.
Setting the charging connector to unlock
automatically
Applies to: vehicles with automatic charging connector un-
locking
You can set if the charging connector should au-
tomatically unlock when the charging process
has ended. This will allow you or others to dis-
connect the charging connector even when the
vehicle is locked. This function is helpful to pre-
vent charging stations from being blocked for
long periods of time, or to allow the charging
connector to be disconnected without a vehicle
key in private locations.
For AC and DC charging, automatic unlocking of
the charging connector is already enabled at the
factory.
» Before charging, always check if the selected
settings are suitable for the current charging
session.
» Applies to: MMI: To enable or disable automatic
unlocking for AC or DC charging processes, se-
lect on the home screen: VEHICLE > Charging >
> AC connector: unlock after charging has
ended or DC connector: unlock after charging
has ended.
1) The function or equipment that is described was in devel-
‘opment at the time this manual was published and may
not be available in your vehicle.
The function should only be activated if the
charging cable is part of the charging station.
Ifyou use your own charging cable, there is no
anti-theft protection and your charging cable
could
be stolen.
Plug & charge”?
Applies to: vehicles with Plug & charge
With Plug & charge, the contract information for
your vehicle charging plan will be stored in the
vehicle. This will allow your vehicle to log in to
public HPC, DC, and AC charging stations auto-
matically, as soon as the vehicle is connected to
the charging station with the charging cable.
Logging in manually and paying with a card or
app will not be necessary. Plug & charge is only
possible at compatible charging stations.
Configuration
Requirement: you must have an active vehicle
charging plan that supports Plug & charge.
— Configure the Plug & charge function in the
myAudi app.
Switching on and off
Only the key user can switch on Plug & charge.
Once Plug & charge has been switched on, all
users can charge using Plug & charge. Authoriz-
ing individual users to use Plug & charge is not
possible. Any user can switch off the service, for
example for an upcoming charging session. The
key user must switch on the service again.
Requirement: you have configured Plug & charge.
Your myAudi user is set as the key user of the ve-
hicle > page 34 and you are logged in as this
user.
— Applies to: MMI: To switch Plug & charge on or
off, select on the home screen: VEHICLE >
Charging > ©} > Plug & charge.
123
OwnersManuals2.com