Audi Q8 e-tron 2024 - Page 182

Parking and maneuvering
Applies to: vehicles with rearview camera/peripheral cameras
Applies to: vehicles with trailer view
Fig. 129 Upper display: trailer view
When parking with the rearview camera or pe-
ripheral camera, the parking system plus audio
and visual warnings* will also assist you
© page 177.
Visual orientation lines
@ The orange orientation lines show the vehi-
cle's direction of travel >@. Turn the steer-
ing wheel until the orange orientation lines
align with the parking space.
@® You can use the horizontal blue markings to
help you estimate the distance to an obsta-
cle. Each marking represents approximately
3 feet (1 meter). The blue surface is a static
display and represents an extension of the
vehicle perimeter to the rear.
@ You can recognize the rear bumper in the
lower display.
@® You should stop driving in reverse when the
red orientation line touches the edge of an
object, at the latest.
180
Trailer view
Applies to: vehicles with trailer view
Requirement: the rearview camera or peripheral
cameras are activated.
— Applies to: vehicles with peripheral cameras:
Switch to the Rear view > page 181, fig. 130.
~ Select [-] > Trailer view in the upper display
when the parking aid is active.
The trailer view © fig. 129 assists you in position-
ing the vehicle in front of a trailer. The orange
orientation line ©) © fig. 129 indicates the ex-
pected path toward the trailer hitch. Use the blue
markings © to help you estimate the distance to
the trailer hitch. Each marking represents ap-
proximately 1 foot (0.30 meters). The width of
the blue surface represents the maximum steer-
ing wheel angle.
symbols
Applies to: vehicles with peripheral cameras
If 2/€9/< is displayed and the display area
represented by that symbol is not available, then
the camera on the that side is not available. The
power exterior mirrors may have been folded in
ora door or the luggage compartment lid may
have been opened.
If #% is displayed, there is a system malfunction
and the display area represented by that symbol
is not available. The camera is not working in this
area.
If Sis displayed, the respective ultrasonic sensor
is icy or dirty. Clean the area in front of the sen-
sors page 141.
If one of the symbols continues to be displayed,
drive immediately to an authorized Audi dealer or
authorized Audi Service Facility to have the mal-
function repaired.
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras © page 138.
— Sensors and cameras have spots in which
the surrounding area cannot be detected.
Objects, animals, and people may only be
detected with limitations or may not be
OwnersManuals2.com