Audi Q8 e-tron 2024 - Page 222

Navigation
Selecting a destination from the map
Applies to: vehicles with navigation system
A point on the map can be used as the destina-
tion.
Opening the map
» Applies to: MMI: Press NAVIGATION on the
home screen.
» If necessary, press /\ to display the map.
Adjusting the scale
» Select: 9/ > select a scale.
Marking the destination
» Press and hold a point on the map until a mark-
ing appears or the address for the selected des-
tination is shown.
Selecting map content (such as POIs) as the
destination
Requirement: map content must be displayed
© page 227.
» Press on map content on the map (for example,
iD.
Selecting the destination
> Select: F > Start.
Stopovers and route plan
Applies to: vehicles with navigation system
You can enter additional destinations during ac-
tive route guidance.
Entering a stopover
Requirement: route guidance must be active.
» Enter a destination 2 page 217.
Displaying stopovers or the route plan
All destinations are listed in the route plan.
» Press on Pin the side menu on the map
© page 221, fig. 148.
Editing stopovers
» Press on Fin the side menu on the map
© page 221, fig. 148.
220
> Adding a stopover: Select: Add destination >
select a destination > Add to route.
» Moving a stopover: press 4. Touch the ¥ sym-
bol and move the entry to the desired position.
Press
Done.
» Deleting a stopover: Select: Z > one or more
entries or Select all > Delete > (Done).
ron route planner
Applies to: vehicles with navigation system and e-tron route
planner
The MMI includes the charging stations along the
route, if the destination cannot be reached with
the current battery charge level.
Requirement: the e-tron route planner must be
switched on © page 227.
Entering a destination with the e-tron route
planner
> Enter a destination.
If the destination is out of range, the fastest
route with stopovers for charging will be sug-
gested automatically.
» To start the suggested route guidance, press
Accept.
» To display the route, press Fi > page 221,
fig. 148 in the map side menu.
The destination is located outside of the
range
The F* symbol will be displayed if the destination
in the current route plan cannot be reached.
> Press on on the map. The route plan will be
displayed.
» Press e-tron route planner to calculate an al-
ternative route with suitable charging stations.
In the e-tron route planner, the following items
will be shown for each destination: the calculated
arrival time, the estimated battery charge level
at arrival | and after charging 5, the suggested
charging duration <=, and the distance from the
current location. >
OwnersManuals2.com