Need help?Do you have a question about the Audio Technica 2000 Series and is the answer not in the manual?
General| Modulation | FM |
|---|---|
| Type | Wireless |
| Dynamic Range | >100 dB |
| Signal-to-Noise Ratio | >100 dB |
| Operating Range | Up to 100 meters (line of sight) |
| Power Supply | 2 x AA batteries (transmitter), DC power supply (receiver) |
| RF Output Power | 10 mW |
| Receiver Type | Diversity |
| Receiver Outputs | Balanced XLR, Unbalanced 1/4" |
| Microphone Type | Handheld |
| Polar Pattern | Cardioid (Handheld) |
| Power Source | Two 1.5V AA batteries |
Proper placement for optimal performance and minimizing interference.
Details on connecting outputs and attaching antennas for best reception.
Explanation of +12V DC output for inline RF devices.
Controls for power, channel display, and manual/auto channel changes.
Indicators for RF signal, tuner operation, and audio modulation levels.
For mounting the receiver in a standard 19" rack.
BNC antenna jacks and DC power input for receiver operation.
XLR/1/4" audio outputs, squelch, attenuator, and level controls.
Disconnects ground pin to prevent hum caused by ground loops.
Recommends AA batteries and provides installation guides for UniPak and handheld transmitters.
How to connect audio sources and information on the UniPak transmitter antenna.
Steps for turning on the receiver and transmitter.
How to change operating channels using receiver buttons.
Adjusting audio input level for the ATW-T220a handheld transmitter.
Adjusting mic/instrument input levels for the ATW-T210a UniPak transmitter.
How to adjust the squelch control for optimal performance and interference reduction.
Technical details for the complete system, UniPak, and handheld transmitters.
Technical details for the ATW-R2100a receiver.
Lists frequency ranges and channels for various bands.
U.S. public safety/security restrictions and land mobile allocation.
Declares compliance with essential requirements of Directive 1999/5/EC.
To Next Page
