To Next PageTo Next PageHow to fix a Audio Technica AT-LP60XBT Turntable when the platter does not spin?
If the platter on your Audio Technica Turntable isn't spinning, try these solutions: * Ensure the AC adapter is properly connected to the outlet. * Make sure the belt is correctly placed on the platter. * Verify the belt is correctly positioned on the motor pulley (brass-colored). * If the belt is damaged or worn, replace it with a new one.
What to do if Audio Technica AT-LP60XBT spins but no sound?
If the platter of your Audio Technica Turntable spins but you're not getting any sound, or the volume is too low, try these steps: * Check the settings on your connected equipment to ensure they are correct. * Inspect the stylus and replace it if needed. * Examine the cartridge and adjust it if necessary. * Verify that the preamplifier settings are correct. If there's no sound or the volume is too low, and the turntable is set to "PHONO," make sure it's connected to the amplifier's AUX/LINE input. If the volume is too loud or distorted, and the turntable is set to "LINE," ensure it's connected to the PHONO input.
Why can't I pair my Audio Technica AT-LP60XBT Turntable?
If you're unable to pair your Audio Technica Turntable, please check if the Bluetooth receiver device communicates using Ver. 2.1+EDR or higher. Place the turntable and the Bluetooth receiver device within 1 m (3.3') of each other.
Why does my Audio Technica Turntable playback speed slow down?
If your Audio Technica Turntable's playback speed slows down or the rotation is irregular, here are some potential solutions: * Clean the stylus tip with a commercially sold brush to remove any dust. * Select the correct speed for your record type using the platter speed button. * Consider replacing the belt with a new one.
How to stop howling from Audio Technica AT-LP60XBT Turntable?
If your Audio Technica Turntable is producing a howling sound, try the following: * Reduce vibrations or mount the turntable on a surface less susceptible to vibrations. * Ensure the surface on which the turntable is mounted is suitable.
General| Type | Belt-drive audio turntable |
|---|---|
| Operation | Fully automatic |
| Motor type | DC servo motor |
| Drive system | V-belt |
| Output level | 150 mV |
| Product color | Black |
| Wow & flutter | 0.25 % |
| Nominal speeds | 33 1/3, 45 RPM |
| Platter material | Aluminum |
| Built-in phono preamplifier | Yes |
| Signal-to-Noise Ratio (SNR) | 50 dB |
| Power supply type | AC |
| AC adapter frequency | 50/60 Hz |
| AC adapter input voltage | 115/230 V |
| Quantity | 1 |
| Cables included | Audio (3.5mm) |
| USB ports quantity | 0 |
Weight and Dimensions| Depth | 373.3 mm |
|---|---|
| Width | 359.5 mm |
| Height | 97.5 mm |
| Weight | 2600 g |
