To Next PageTo Next Page
Need help?Do you have a question about the Audio Technica AT-LP60XUSB and is the answer not in the manual?
General| Drive Method | Belt Drive |
|---|---|
| Type | Fully Automatic |
| Speeds | 33-1/3 RPM, 45 RPM |
| USB Output | Yes |
| Replacement Stylus | ATN3600L |
| Platter | Aluminum |
| Motor | DC servo-controlled |
| Phono Pre-Amp Gain | 36 dB nominal, RIAA equalized |
| Phono Preamp | Built-in switchable phono preamp |
| Cartridge | AT3600L |
| Dimensions | 359.5 mm x 97.5 mm x 373.3 mm |
| Weight | 2.6 kg |
| Wow and Flutter | < 0.25% (WTD) @ 3 kHz |
| Signal-to-Noise Ratio | > 50 dB |
| Output Level | 150 mV nominal at 1 kHz, 5 cm/sec |
| Power Supply | 100 to 240 V, 50/60 Hz |
| Power Consumption | 1W |
| USB Function | A/D, D/A - 16-bit/44.1 kHz or 48 kHz USB selectable |
| Tonearm | Static balance tonearm |
| Stylus | 0.6 mil conical |
| Outputs | RCA, USB |
| USB ADC | 16-bit, 44.1/48 kHz sampling |
Unpacking, attaching the drive belt, and installing the cartridge/stylus.
Placing the turntable platter and securing the lid.
Wiring the turntable audio outputs to an external audio system.
How to choose the correct speed and size for playing records.
Instructions for using the automatic start and stop features.
Steps for manual operation, including tonearm placement.
Procedures for stopping the turntable during or after playback.
Best practices for cleaning the stylus and records.
