Replacing the belt
• The belt is a consumable part. Replace the belt if the speed of
playback slows down or irregular rotation occurs. As a rule of thumb,
we suggest replacing the belt once a year.
• Before replacing the belt, be sure to disconnect the product’s power
cable plug from the outlet.
1. Remove the old belt.
2. Attach the new belt to the platter first, and then attach it to the
motor pulley.
• When attaching the belt to the motor pulley, make sure that the belt does
not get twisted.
Adjusting the tonearm's height
When installing a cartridge other than the one provided, you must
maintain a suitable distance between the cartridge and the surface of
the record. Place the stylus on the record and confirm that the tonearm
is parallel to the record's surface. If it is not parallel, adjust the height
of the tonearm.
1. Rotate the tonearm's height setting lever to loosen the tonearm's
anchor.
2. Rotate the tonearm's height adjustment dial and adjust the
tonearm's height.
3. After the adjustments are complete, rotate the tonearm's height
setting lever to set the tonearm.
Guideline
To Next Page
Loading...
Need help?
General
