24
Forced pairing mode / reset
If the product does not connect to a device (forced pairing
mode)
If pairing cannot be cancelled or is not successful, you can use forced pairing mode to perform pairing again.
1
With the product turned on, press and hold (about 6 seconds) the volume buttons (+/–) at the same
time.
The product will switch to the “searching for devices” (pairing mode) state and you will be able to
pair with your desired Bluetooth device.
If the product operates abnormally (reset)
Reset the product.
1
With the product turned on, press and hold (about 6 seconds) the volume buttons (+/–) at the same
time.
2
Make sure the indicator lamp is flashing rapidly in white, and press and hold the power supply /
control button and the volume up button (+) at the same time (for about 6 seconds).
The indicator lamp will light in pink, and after the product restarts, reset is complete.
3
Remove the product from the list of registered devices on your Bluetooth device.
4
Pair the product again.
To Next Page
Loading...
Need help?
General
