1. Getting Started with Initial Connectivity
M500Li Analog VoIP Gateway
- 4 -
1 Getting Started with Initial Connectivity
1.1 Introduction
This part describes how to initially access the device's management interface and change its
default IP address to correspond with your networking scheme.
Device management can always be done through the LAN interface. It can also be
enabled for the WAN interface as explained in section 1.3.2, Configuring the WAN
Interface on page 7.
1.2 Accessing the Device's Management Interfaces
This section describes initial access to the device's management interface.
1.2.1 Connecting to the Web Interface
You can access the Web- based management interface using the device's default LAN IP address:
Table 1-1: Default LAN IP Address
By default, the device's embedded DHCP server is enabled for the LAN, and with default
IP pool addresses relating to the default subnet LAN. The DHCP server allocates this pool
of IP addresses to computers connected to its LAN interface. You can disable the DHCP
server or modify the IP address pool.
To Next Page
Loading...
Need help?
General
