Polish [AudioCodes Ltd], deklarujemy z pelna odpowiedzialnoscia, ze wyrób [MP-11x/FXS-FXO Series] spelnia podstawowe wymagania i
odpowiada warunkom zawartym w dyrektywie 89/336/EEC, 73/23/EEC; 1999/5/ES
Portuguese [AudioCodes Ltd] declara que este [MP-11x/FXS-FXO Series] está conforme com os requisitos essenciais e outras disposições da
Directiva 89/336/EEC, 73/23/EEC; 1999/5/ES.
Slovak [AudioCodes Ltd] týmto vyhlasuje, že [MP-11x/FXS-FXO Series] spĺňa základné požiadavky a všetky príslušné ustanovenia Smernice
89/336/EEC, 73/23/EEC; 1999/5/ES.
Slovene Šiuo [AudioCodes Ltd] deklaruoja, kad šis [MP-11x/FXS-FXO Series] atitinka esminius reikalavimus ir kitas 89/336/EEC, 73/23/EEC;
1999/5/ES Direktyvos nuostatas.
Spanish Por medio de la presente [AudioCodes Ltd] declara que el [MP-11x/FXS-FXO Series] cumple con los requisitos esenciales y
cualesquiera otras disposiciones aplicables o exigibles de la Directiva 89/336/EEC, 73/23/EEC; 1999/5/ES
Swedish Härmed intygar [AudioCodes Ltd] att denna [MP-11x/FXS-FXO Series] står I överensstämmelse med de väsentliga egenskapskrav och
övriga relevanta bestämmelser som framgår av direktiv 89/336/EEC, 73/23/EEC; 1999/5/ES.
Safety Notice
Installation and service of this unit must only be performed by authorized, qualified service personnel.
To avoid risk of fire use 26AWG or higher wiring to connect the FXS or FXO telecom ports.
Telecommunications Safety
The safety status of each port on the gateway is declared and detailed in the table below:
Ports Safety Status
Ethernet (100 Base-T) SELV
FXS
TNV-3
FXO
TNV-3
TNV-3: Circuit whose normal operating voltages exceeds the limits for an SELV circuit under normal operating conditions and on which
over voltages from Telecommunication Networks are possible.
SELV: Safety extra low voltage circuit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and
can and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Analog Fast Track Guide 4.8
To Next Page
Loading...
Need help?
General
