AudioCodes MediaPack MP-114 Fast Track Guide

MediaPack
Analog Fast Track Guide 32 Document #: LTRT-59802
Figure 7-5: Load a CPT File Screen
7. Follow the same procedure you followed when loading the ini file (refer to Step 6). The same
procedure applies to the ‘Load a VP file’ (not applicable to the MediaPack gateway) screen
and ‘Load a coefficient file’ screen.
8. In the ‘FINISH’ screen (refer to Figure 7-6), the Next button is disabled. Complete the
upgrade process by clicking Reset or Cancel.
¾ Click Reset, the MediaPack ‘burns’ the newly loaded files to flash memory. The
‘Burning files to flash memory’ screen appears. Wait for the ‘burn’ to finish. When it
finishes, the ‘End Process’ screen appears displaying the burned configuration files
(refer to Figure 7-7).
¾ Click Cancel, the MediaPack resets, utilizing the files previously stored in flash memory.
(Note that these are NOT the files you loaded in the previous Wizard steps).
Figure 7-6: FINISH Screen

AudioCodes MediaPack MP-114 Specifications

General

Model	MP-114
Category	Gateway
Analog Ports	4 FXS
Network Interfaces	2 x 10/100Base-T Ethernet
Voice Codecs	G.711, G.726, G.723.1, G.729A/B
Fax Support	T.38
Management	Web-based management, CLI, SNMP
Security	SRTP, TLS, HTTPS
Ports	4 RJ-11, 2 RJ-45
Protocols	SIP, H.323
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90%, non-condensing